AT&T 9002 Headset Jack

Headset Jack

You can use this telephone hands-free when you install an optional headset

and use the belt clip provided.

1Attach the belt clip (see “Belt Clip” in the INSTALLATION section of

this manual).

2Plug the headset (purchased separately) into the jack located on

the right side of the handset. (For best results, use only an accessory

headset with 2.5 mm plug.) Do not force the connection, but make

sure the plug fits securely.

3Follow instructions under “Making a Call” or “Answering a Call.”

NOTE: The earpiece and microphone on the handset are disabled when the

headset is plugged in.

OPERATION

9002_book.1AT&T 8/12/98, 4:09 PM13

Contents

Main Page CONTENTS INSTALLATION................................. 3 OPERATION..................................... 7 OPERATING RANGE........................ 14 TELEPHONE MEMORY.................... 15 BATTERIES.................................... 16 Page Table/Desk Installation Page Wall Installation Belt Clip Page Page Making a Call Answering a Call Ending a Call Redial Handset Ringer Selection and Ringer OFF Handset Ringer Volume Base Ringer Volume Speakerphone Volume Temporary Tone Special Telephone Services Hold Mute (Base Only) Page Conference Calls Switching a Conference Call to the Base Four-Way Conference Calls Headset Jack OPERATING RANGE TELEPHONE MEMORY Charging the Handset Battery Pack Replacing the Handset Battery Pack BATTERIES Page If the phone doesnt work at all, check these items first: If the above suggestions dont solve the problem, try re-initializing the handset and base: If you hear noise or interference when using the phone. IN CASE OF DIFFICULTY If the phone does not ring when you receive a call: If you hear other calls while using your phone: