Operation

Light goes on when intercom is in use

Volume HI/LO switch

Line 1 – Make or answer a call

Line 2 – Make or answer a call

Line 1 and Line 2 buttons flash if base or extension is in use

Temporary tone

Store and access numbers in telephone

memory

Connect parties to conference call

Headset jack

Light goes on when handset battery is low

End a call

Change channel

Begin two-way communication with base

Put a caller on hold

Redial last number dialed

8/12/98, 4:09 PM

Image 10

Contents

Part Philips Consumer Communications L.P. All rights reserved Contents 9002book.1AT&T 12/98, 409 PM Table/Desk Installation InstallationSet the dial mode Charge the handset batteries for 16 hours Connect the power cordConnect the telephone line cords to the base Check for dial tone Wall Installation Connect the line cords Belt Clip Follow Steps 7 and 8 under Table/Desk InstallationMount the telephone on the wall jack Operation Operation Ending a Call Making a CallAnswering a Call Redial Speakerphone Volume Handset Ringer VolumeBase Ringer Volume Temporary Tone Mute Special Telephone ServicesHold Intercom Conference Calls Switching a Conference Call to the BaseFour-Way Conference Calls Headset Jack Operating Range Telephone Memory Replacing the Handset Battery Pack Charging the Handset Battery PackBatteries Batteries Case of Difficulty If you hear noise or interference when using the phoneIf the phone doesn’t work at all, check these items first If the phone does not ring when you receive a call If you hear other calls while using your phone

AT&T 9002 user manual Operation