AT&T 9002 user manual Connect the telephone line cords to the base, Connect the power cord

INSTALLATION

4Connect the telephone line cord(s) to the base.

•If you have a two-line jack, use only the white line cord. Plug one end into the jack labeled L1/L2 on the back of the base.

•If you have two separate jacks, use both the white and clear line cords. Insert one end of the white line cord into the jack labeled L1/L2 on the back of the base. Plug one end of the clear line cord into the jack labeled L2 on the back of the base.

5Connect the telephone line cord(s) to the modular telephone jack(s).

•If you have a two-line jack, plug the free end of the white line cord into the modular telephone jack. Make sure the cord snaps firmly into place.

•If you have two separate jacks, plug the free end of the white line cord into the modular telephone jack for Line 1. Plug the free end of the clear line cord into the modular telephone jack for Line 2. Make sure the cords snap firmly into place.

6Connect the power cord.

Plug the power adapter into the jack labeled 9V DC on the back of the base. Plug the AC adapter on the power cord into an electrical outlet.

7Charge the handset batteries for 16 hours.

Place the handset face down in the base. The CHARGING light on the base goes on to show the handset is in the right position to charge the batteries.

8Check for dial tone.

After the batteries are charged, press L, and listen for a dial tone. Then press l. If you do not hear a dial tone, turn to IN CASE OF DIFFICULTY in this manual.

4

9002_book.1AT&T 4 8/12/98, 4:09 PM