Batteries

5The new battery pack must be charged before using this telephone. Place the handset in the base and allow it to charge for 16 hours. Your telephone might operate before that, but for best performance, let the handset battery pack charge fully.

9002_book.1AT&T

8/12/98, 4:09 PM

Page 19

Image 19

Contents

Part Philips Consumer Communications L.P. All rights reserved Contents 9002book.1AT&T 12/98, 409 PM Table/Desk Installation InstallationSet the dial mode Check for dial tone Connect the power cordConnect the telephone line cords to the base Charge the handset batteries for 16 hours Connect the line cords Wall Installation Belt Clip Follow Steps 7 and 8 under Table/Desk InstallationMount the telephone on the wall jack Operation Operation Redial Making a CallAnswering a Call Ending a Call Temporary Tone Handset Ringer VolumeBase Ringer Volume Speakerphone Volume Intercom Special Telephone ServicesHold Mute Conference Calls Switching a Conference Call to the BaseFour-Way Conference Calls Headset Jack Operating Range Telephone Memory Replacing the Handset Battery Pack Charging the Handset Battery PackBatteries Batteries Case of Difficulty If you hear noise or interference when using the phoneIf the phone doesn’t work at all, check these items first If you hear other calls while using your phone If the phone does not ring when you receive a call

AT&T 9002 user manual Batteries

Models: 9002

BATTERIES

9002_book.1AT&T