AT&T 9002 user manual Wall Installation, Connect the line cords

INSTALLATION

Wall Installation

2-line Wall Jack

Wall

Mounting

Base

1Follow Steps 1–3 under Table/Desk Installation.

2Turn the base unit over, and attach the wall mounting base to the lower half of the base unit. Gently press down until it snaps firmly into place.

3Connect the power cord.

Plug the power cord into the power jack on the back of the base. Run the cord under the tab on the bottom of the base and under the tab on the wall mounting base. Plug the AC adapter into an electrical outlet not controlled by a wall switch.

4Connect the line cord(s).

•If you have a two-line jack, use the short white line cord (see illustration above). Insert one end of the short telephone line cord into the telephone jack labeled L1 or L1/L2 on the rear of the telephone base. Feed the excess line cord under the tab on the bottom of the telephone base. Plug the line cord into a two-line wall jack. You will be connected to Lines 1 and 2

— OR —

•If you have two separate jacks, use the short white line cord, and the long clear line cord. Insert one end of the short white telephone line cord into the telephone jack labeled L1 or L1/L2 on the rear of the telephone base. Feed the excess line cord under the tab on the bottom of the telephone base. Plug the short line cord into the standard one-line wall jack. You will be connected to Line 1.

Insert one end of the long clear telephone line cord into the telephone jack labeled L2 on the rear of the telephone base. Feed

5

9002_book.1AT&T 5 8/12/98, 4:09 PM