5.1ASSEMBLY INSTRUCTIONS FOR 72" CUTTER DECKS

-NOTE-

Use the illustrated parts list as a part

number reference when following the assembly instructions.

1.Remove all packaging materials. Lay out the mounting hardware and the catcher assembly parts for easy access. Prepare the work area making sure that it is a clean, safe environment.

2.Remove the discharge chute from the cutter deck. See Figure 5-1.

3.When installing this grass catcher on a machine with a serial number below 8619999, you will need to remove the discharge baffle from the bottom of the cutter deck. See Figure 5-2. Replace the discharge baffle with the new baffle provided with this grass catcher. Secure using the following hardware:

(1)04001-12 Hex Head Bolt 5/16-18 x 1-3/4"

(1)04001-09 Hex Head Bolt 5/16-18 x 1"

(3)04040-15 Flatwasher

(3)04021-10 Nut, Elastic Stop 5/16-18

When installing this grass catcher on an Advantage deck, install the front baffle to the cutter deck. See Figure 4-2. Secure using the

REMOVE DISCHARGE CHUTE AND HARDWARE

REMOVE (2)

U-NUTS

INSTALL PULLEY

ON RH SPINDLE SHAFT -

ON TOP OF EXISTING

SPINDLE DRIVE

PULLEY

REMOVE EXISTING

RT. SIDE BELT

 

 

COVER

RIGHT SIDE OF

CUTTER DECK SHOWN

following hardware:

(2)04017-05 Bolt, Hex Head 1/4-20 x 3/4"

(2)04019-02 Nut, Serrated Flange 1/4-20

(2)04003-23 Bolt, Carriage 3/8-16 x 1"

(2)04041-07 Flatwasher

(2)04021-09 Nut, Elastic Stop 3/8-16

04019-02 04003-23

(Note: Some parts not shown for viewing purposes.)

FIGURE 5-1

-NOTE-

Do not discard the discharge chute or mounting hardware. The discharge chute MUST be reinstalled anytime the grass catcher has been removed from the machine.

WARNING

DO NOT OPERATE WITHOUT DISCHARGE CHUTE, MULCHING KIT, OR ENTIRE GRASS CATCHER INSTALLED

04017-05

04021-09

04021-09 04041-07

04041-07

Discharge

Baffle

04001-09

04040-15

04021-10

FIGURE 5-2

4.Remove the right side belt cover to gain access to the spindle assembly. Remove the two front u-nuts from the cutter deck bracket. See Figure 5-1.

5.Install the grass catcher pulley onto the spindle assembly. Apply loctite to both pulley setscrews and tighten. See Figure 5-1.

11

Page 13
Image 13
Scag Power Equipment GC-STT-CS manual Assembly Instructions for 72 Cutter Decks