Scag Power Equipment GC-STT-V operating instructions Grass Catcher Removal Instructions

4.1GRASS CATCHER REMOVAL INSTRUCTIONS

1.Prepare the work area making sure that it is a clean, safe environment.

2.Remove the bag assemblies from the grass catcher.

3.Remove the rubber strap holding the adapter to the blower assembly. See Figure 4-1.

4.Remove the belt from the spindle pulley and the large hair pin securing the blower to the discharge chute mounting hole.

5.Remove the mounting pin, hair pin and quick pin securing the blower assembly to the cutter deck and remove the blower assembly. See Figure 4-1.

ADAPTER

BLOWER

ASSEMBLY

QUICK PIN

PIN & HAIR PIN

MOUNTING

BRACKET

RIGHT SIDE OF

CUTTER DECK SHOWN

2006 GC-STC-V removal art 1

(Note: Some parts not shown for viewing purposes.)

Figure 4-1

6.Remove the two (2) pins holding the hood assembly to the mounting brackets on the rear of the machine. See Figure 4-2.

REMOVE

	HOOD OUT
ASSEMBLY
PULL

REMOVE

Figure 4-2

7.Remove the hood assembly.

8.Remove the front weights by removing the quick pins.

9.Re-install the side discharge chute to the opening on the cutter deck. Replace the two (2) outside mounting bolts on the discharge chute with the clevis pins (p/n 04064-15) and rue cotter pins (p/n 04069-03). See Figure 4-3.

10.Re-install the cutter deck belt cover.

DISCHARGE

CHUTE

	CLEVIS PIN
	P/N 04064-15
CLEVIS PIN
P/N 04064-15	RUE COTTER PIN
GC-STC-V removal art 3	P/N 04069-03

Figure 4-3

WARNING

DO NOT OPERATE WITHOUT DISCHARGE CHUTE, MULCHING KIT, OR ENTIRE GRASS CATCHER INSTALLED

7