Scag Power Equipment GC-STT-V Install the hose from the blower assembly to the

13.Install the hopper mounting brackets (p/n 451512) to the outside of the frame on the rear of the machine using 3/8-16 x 1" hex head bolts

(p/n 04001-19) and 3/8-16 elastic stop nuts (p/n 04021-09). See Figure 3-8, Page 6.

14.Install the hopper hood assembly onto the catcher frame assembly and secure with 3/8-16 x 2-1/4" hex head bolts (p/n 04001-46) and 3/8-16 elastic stop nuts (p/n 04021-09) in the mounting holes. See Figure 3-8, Page 6.

15.Install the catcher support bracket onto the rear of the machine and secure with 5/16-18 x 1" carriage bolts (p/n 04003-04) and 5/16-18 serrated flange nuts (p/n 04019-03) See Figure 3-6.

Catcher Support Bracket

FIGURE 3-6

16.Install the heat shield to the hopper hood assembly and catcher frame assembly. Secure using the hardware specified in Figure 3-8, Page 6.

17.Install adapter (p/n 461723) to the blower assembly and secure with the strap.

18.Install the hose from the blower assembly to the

hopper hood. Secure using the 8-1/2" clamps.

-NOTE-

When installing this catcher on machines equipped with an air-cooled engine the discharge hose should be shortened to 56" in length.

19.Install the bag assemblies.

20.Install the weight support bar to the front of the machine by resting it directly on top of the caster support arms and sliding it tight against the frame of the machine. Secure the weight bar to the machine using (2) bar clamps, (4) 3/8-16 x 1-1/2" bolts and (4) 3/8-16 elastic stop nuts. See Figure 3-7.

21.Install the weight assemblies to the weight support bar and secure them to the bar using the 1/2"x 6-1/4" pin and lanyard. See Figure 3-7.

WEIGHT (5x)

LANYARD

ELASTIC STOP PIN

NUT

BAR CLAMP

	BOLT
WEIGHT SUPPORT BAR	2002 GC-STT Install Art 3-5

FIGURE 3-7

21. Operate and test.

5