Scag Power Equipment GC-STWC-CS61V manual Grass Catcher Removal Instructions

4.1GRASS CATCHER REMOVAL INSTRUCTIONS

1.Prepare the machine so there is easy and safe access to the work area. Remove the key and maintain all safety related work procedures.

Always wear eye and hand protection.

2.Remove the rubber strap holding the adapter to the blower assembly and the large quick pin securing the blower to the discharge mounting bracket. See Figure 4-1.

3.Remove the belt, pin, hair pin and large quick pin securing the blower assembly to the cutter deck and remove the blower assembly. See Figure 4-1.

ADAPTER

BLOWER

ASSEMBLY

QUICK PIN

PIN & HAIR PIN

MOUNTING

BRACKET

RIGHT SIDE OF

CUTTER DECK SHOWN

2006 GC-STC-V removal art 1

(Note: Some parts not shown for viewing purposes.)

Loosen
Locking	Remove
Bolts
	Mounting
	Pins

Loosen
Locking	Remove
Bolts	Mounting
	Pins

2005 GC-STC removal art 2-A

FIGURE 4-2

5.With help from an assistant, remove the hopper assembly.

WARNING

DO NOT OPERATE WITHOUT DISCHARGE CHUTE, MULCHING KIT, OR ENTIRE GRASS CATCHER INSTALLED

6.Re-install the side discharge chute to the opening on the cutter deck. Replace the two outside mounting bolts on the discharge chute with the clevis pins (p/n 04064-15) and rue cotter pins (p/n 04069-03). See Figure 4-3.

7.Re-install the cutter deck belt cover.

DISCHARGE

CHUTE

FIGURE 4-1

4.Loosen the locking bolts and remove the two (2) pins holding the hood assembly to the mounting posts on the rear of the machine. See Figure 4-2.

	CLEVIS PIN
	P/N 04064-15
CLEVIS PIN
P/N 04064-15	RUE COTTER PIN
GC-STC-V removal art 3	P/N 04069-03

FIGURE 4-3

6