Scag Power Equipment STC operating instructions Troubleshooting Contd Condition Cause Cure

Section 5

TROUBLESHOOTING (CONT'D)

CONDITION	CAUSE	CURE
Uneven Cut on Flat	Lift worn from blade	Replace blade
Ground - Wavy
High-Low	Blade upside down	Mount with cutting edge toward
Appearance,		ground
Scalloped Cut, or
Rough Contour	Deck plugged, grass accumulation	Clean underside of deck
	Too much blade angle (deck pitch)	Adjust pitch and level
	Deck mounted improperly	See your authorized SCAG dealer
	Bent spindle area	See your authorized SCAG dealer
	Dull blade	Sharpen blade
Width of Deck
SGB020
Uneven Cut on	Uneven ground	May need to reduce ground speed,
Uneven Ground -		raise cutting height, and/or change
Wavy Appearance,		direction of cut
High-Low Scalloped
Cut, or Rough Contour

Width of Deck
SGB021
Sloping Ridge Across	Tire pressures not equal	Check and adjust tire pressure
Width of Cutting Path
	Wheels uneven	Check and adjust tire pressure
	Deck mounted incorrectly	See your authorized SCAG dealer

Deck not level side-to side

Check for level and correct

Width of Deck

SGB023

19