Scag Power Equipment STHM manual 3-1/2 Custom-CutBaffle Position, 4 Custom-CutBaffle Position

A.3" Position - baffle is installed using the top set of holes on the front baffle welded inside the cutter deck. (See Figure 15). The Advantage cutter deck will deliver the best quality-of-cut in very tall, wiry, tough to cut grass.

B.3-1/2" Position (factory setting) - baffle is installed using the middle set of holes on the front baffle welded inside the cutter deck. (See Figure 16). For general purpose cutting, place the Custom Cut Baffle in the 3-1/2" position. This gives the best mix of cutting performance in all types of grass.

C.4" Position - baffle is installed using the bottom set of holes on the front baffle welded inside the cutter deck . (See Figure 17). Placing the baffle in the 4" setting will enhance fall cutting (leaf pickup) and reduce cutter deck "blowout".

To adjust the Custom-Cut Baffle height:

1.Place the cutter deck in the transport position.

2.Remove the hardware securing the Custom-Cut Baffle to the cutter deck. (See Figure 14).

-NOTE-

Hardware location used in the illustrations are for reference only. Location of hardware may vary depending on cutter deck size.

MOUNTING	MOUNTING
HARDWARE
	HARDWARE

2004 CCB

Figure 14. Custom-Cut Baffle

3.Move the Custom-Cut Baffle to desired position. (See Figures 15through 17 for position).

4.Reinstall the mounting hardware as shown. (See Figures 15 though 17). Torque hardware to 39ft.lbs.

TOP SET OF HOLES	CARRIAGE BOLT
FOR 3" SETTING

	2004 CCB - 3" Setting
FLATWASHER	ELASTIC STOP
	NUT
Figure 15. 3" Custom-Cut Baffle Position
MIDDLE SET OF HOLES
	CARRIAGE BOLT
FOR 3-1/2" SETTING

	2004 CCB - 3-1/2" Setting
FLATWASHER	ELASTIC STOP
	NUT
Figure 16. 3-1/2" Custom-Cut Baffle Position
BOTTOM SET OF HOLES
	CARRIAGE BOLT
FOR 4" SETTING

	2004 CCB - 4" Setting
FLATWASHER	ELASTIC STOP
	NUT

Figure 17. 4" Custom-Cut Baffle Position

12