BEFORE OPERATING | WHILE OPERATING |
1.Know the operating controls and how to stop quickly.
2.Do not allow children to operate the machine. Do not allow adults to operate the machine without proper instruction.
3.Remove all debris or other objects that might be picked up and thrown by the cutter blades. Keep all bystanders away from the mowing area.
4.Keep all shields, safety devices, and decals in place. If a shield, safety device or decal is defec- tive or damaged, repair or replace it before operating. Also, check all nuts, bolts and screws for proper tightness, to assure the machine is in safe operating condition.
5.Do not operate the machine while wearing sandals, tennis shoes, sneakers or shorts. Also, do not wear loose fitting clothing which could get caught in moving parts. Always wear long pants and substantial shoes. Wearing safety glasses and safety shoes is advisable and required by some local ordinances and insurance regulations.
6.Fill the fuel tank with clean, fresh gasoline, with a minimum octane rating of 87. Avoid spilling gasoline. Gasoline is highly flammable, handle it carefully.
A.Use an approved gasoline container.
B.Do not fill the tank while the engine is hot or running.
C.Do not smoke while handling gasoline.
D.Fill the fuel tank outdoors and up to approxi- mately 1" (25 mm) below the bottom of the filler neck.
E.Wipe up any spilled gasoline.
7.Before attempting to start the engine, move the blade engagement switch to the OFF position and apply the parking brake.
1.Start the engine when the cutter blades are disengaged, the parking brake is on and the right foot pedal is in the neutral position.
2.Do not run the engine in a confined area without adequate ventilation. Exhaust fumes are hazard- ous and could possibly be deadly.
3.Using the machine demands attention. To prevent loss of control:
A.Mow only in daylight or when there is good artificial light.
B.Watch for holes or other hidden hazards.
C.Do not drive close to a
D.Reduce speed when making sharp turns and when turning on hillsides.
E.Do not operate where conditions are slippery.
4.The discharge chute must always be installed and in the down position on the side discharge cutter deck except when the Scag optional grass catcher or mulching plate are properly installed. If the discharge area should plug, shut the engine off and wait for all movement to stop before removing the obstruction.
5.Disengage the blades and wait for them to stop before crossing gravel drives, walks or roads.
6.Shut the engine off and wait until the blades come to a complete stop before removing the grass catcher container.
7.Never raise the cutter deck while the blades are rotating.
8.Always park the mower and/or start the engine on a level surface. Apply the parking brake to prevent the mower from moving when you are not in the operator’s position.
4
