R
Section 6
ADJUSTMENTS
6.1 DRIVE CONTROL ADJUSTMENTS
1.Adjust the steering control rods so that there is approximately 3/4" clearance from the bottom of the rod to the bottom of the neutral latch slot when in the drive position. See Figure
2.Adjust the steering brake rods so that the brakes do not apply until the steering levers are pulled tight to the handles. When the steering levers are locked in the neutral position the machine should move freely.
Neutral
Latch
Neutral Lock
Position
Drive Position
3/4"
Steering
Brake Lever
SC404GB05
6.3 CUTTER DECK BELT ADJUSTMENTS
WARNING
Before removing any guards, shut the engine off and remove the ignition key. Wait for all moving parts to come to a complete stop before beginning work.
1.Remove the belt cover.
2.Adjust the cutter deck drive belt using a belt tension gauge. Adjust the belt so that the belt moves 1/2" with 10 pounds of pressure. Adjust the tension by tightening or loosening the
End Of | "J" Bolt | Belt |
Bracket |
| |
|
| |
Nut |
|
|
Washer |
|
|
Figure 6-1. Steering Control Rod Adjustment
- NOTE -
Operator pressence lever removed for clarity. Never operate equipment with the interlock system disconnected.
6.2Throttle Control and Choke Adjustments
These adjustments must be performed by your Scag dealer to ensure proper and efficient running of the engine. Should either need adjustment, contact your authorized Scag service center.
CUTTER DECK DRIVE BELT TENSION | SC400G |
| |
ALIGNMENT IDLER - L.H. |
|
Figure 6-2. Deck Drive Belt Adjustment
Due to initial belt stretch and to prevent the belt from slipping, check this adjustment after the first 2 hours, 4 hours and 8 hours of operation.
3.Adjust the RH blade drive belt using a belt tension gauge. Adjust the belt so that the belt moves 1/2" with 10 pounds of pressure. Adjust the tension by tightening or loosening the
18