Scag Power Equipment SZC manual 7. Custom-Cut Baffle, 9. 3-1/2 Custom-Cut Baffle Position

Section 6

To adjust the Custom-Cut Baffle height:

1.Place the cutter deck in the transport position.

2.Remove the hardware securing the Custom-Cut Baffle to the cutter deck. (See Figure 6.7).

-NOTE-

Hardware location used in the illustrations are for reference only. Location of hardware may vary depending on cutter deck size.

MOUNTING	MOUNTING
HARDWARE
	HARDWARE

2004 CCB

Figure 6-7. Custom-Cut Baffle

MIDDLE SET OF HOLES	CARRIAGE BOLT
FOR 3-1/2" SETTING

	2004 CCB - 3-1/2" Setting
FLATWASHER	ELASTIC STOP
	NUT
Figure 6-9. 3-1/2" Custom-Cut Baffle Position
BOTTOM SET OF HOLES
	CARRIAGE BOLT
FOR 4" SETTING

	2004 CCB - 4" Setting
FLATWASHER	ELASTIC STOP
	NUT

Figure 6-10. 4" Custom-Cut Baffle Position

3.Move the Custom-Cut Baffle to desired position. (See Figures 6.8 through 6.10 for position).

4.Reinstall the mounting hardware as shown. (See Figures 6.18 though 6.10). Torque hardware to 39 ft/ lbs.

TOP SET OF HOLES	CARRIAGE BOLT
FOR 3" SETTING

	2004 CCB - 3" Setting
FLATWASHER	ELASTIC STOP
	NUT

Figure 6-8. 3" Custom-Cut Baffle Position

27