Schneider Electric 560110R Wiring Diagrams, Single amplifier standalone installation diagram

Multi Room Audio Amplifier Installation Instructions

2.3Wiring Diagrams

Wiring diagrams are provided for typical installations using one amplifier (Figure 1) and more than one amplifier (Figure 2). Note that multiple amplifiers have one analogue input source and a digital audio connection between the amplifiers.

When making wiring connections, it is important to follow these guidelines:

•Do not plug a C-Bus network cable into a Digital Audio socket. You could damage the amplifier.

•Consistent speaker wiring polarity is important for good sound quality. If you use multiple speakers with an amplifier, follow the speaker manufacturer's recommendations.

•Speaker placement is important. You might have to move speakers to get the best results.

•Keep cable runs as short as possible.

•Use high quality cables of the proper type for the intended purpose. Refer to the information in the following subsections.

The wiring diagram in Figure 1 shows the connections for one amplifier with a single pair of speakers.

Figure 1. Single amplifier standalone installation diagram

In multiple amplifier installations, the amplifiers share a single audio source. The volume and tone settings for each amplifier can be independently controlled.

An RJ45 Tee connector, Catalogue Number 5600TEE, is needed to connect the Digital Audio signals between multiple 560110R Low Power Remote Amplifiers.

Do not make any electrical connections between the speakers on any two amplifiers or connect any speaker wiring to earth (ground). Poor sound quality will result.

9