InRow RC Operation and Maintenance Manual12
Stop the cooling unit
1. To stop the cooling unit, press the ENTER key until the cursor is on the Operation > On/Standby menu
item.
2. Press the ENTER key again to show the toggle state arrow to the right of Operation.
3. Use the up and down arrow keys to change from On to Standby.
See “Path: Main > Operation > Limit Access” on page 11 if you are prompted to enter a
password before changing the On/Standby setting.
4. Press the ENTER key again to change the setting to Standby. The cooling unit will enter the standby
mode.
DANGER
HAZARD OF ELECTRIC SHOCK, EXPLOSION, OR ARC FLASH
• Apply appropriate personal protective equipment (PPE) and follow safe electrical work
practices. See NFPA 70E or CSA Z462.
• This equipment must be installed and serviced by qualified personnel only.
• Turn off all power supplying this equipment before working on or inside the equipment.
• Always use a properly rated voltage sensing device to confirm power is off.
• Replace all devices, doors, and covers before turning on power to this equipment.
Failure to follow these instructions will result in death or serious injury.
CAUTION
STANDBY OPTION
The Standby option does not remove power from the cooling unit. You must disconnect
power at the mains to remove power from the cooling unit.
Failure to follow these instructions can result in equipment damage.