Schneider Electric RS232 manual Monitoring, Updating the Controller, Connection Test

b) Problems Related to Transferring Data between the PC and the ZelioLogic SR2/SR3:

Problems	Solutions
Monitoring :
With Windows 98 and Me :
When Monitoring, if you open a		From the workshop :
window or another program than Zelio Soft 2,		Return to Edit mode then back into
the controller may switch off and all the	Monitoring mode and press the controller's
inputs outputs on the workshop side switch to	On button.
ON. This problem may also occur if you		On the controller :
scroll down to the bottom of the programming		Go into the fault menu and
sheet.	acknowledge fault 58.
Updating the Controller :
With Windows XP PRO :
Updating the controller may cause		Close all the applications open (in
communication to be lost.	particular the programming window) and run
	the	software	update	again,	since
	communication was lost the controller display
	is blank since the start-up program is no
	longer there, that is why when you perform
	this operation the software will ask you to
	identify yourself the controller model (the
	type and the 8-figure code are marked on the
	side of the housing). Repeat this operation
	several times if it does not work first time
	around.
		If the problem persists, re-load the
	controller program using an RS 232 output
	(disconnect the USB-RS232 cable).
Connection Test:
The connection may not operate after		Go into ‘Device Manager’, ‘Ports
installing the USB RS232 cable.	(com and Lpt)’, ‘USB TO Serial Port’,
	‘Properties’, ‘Drivers’ and run a driver update
	(repeat the installation operations).

4