Read Rules for

MODEL MKC-10

Safe Operation

10 AMP 12 VOLTS

and Instructions

BATTERY CHARGER

Carefully

WARNING: Working in the vicinity of a lead-acid battery is dangerous. Batteries generate explosive gases during normal battery operation. For this reason, it is of utmost importance that each time before using your charger, you read this manual and follow the instructions exactly.

GENERAL BATTERY SAFETY

1.Before you use your battery charger, be sure to read all instructions and cautions printed on:

●Battery Charger

●Battery

2.Use battery charger on LEAD ACID type rechargeable bat- teries only, such as used in autos, trucks, tractors, airplanes, vans, RV's, trolling motors, etc. Charger is not intended to supply power to low-voltage electrical system other than in an automotive or boat/marine application.

WARNING: Do not use battery charger for charging dry-cell batteries that are commonly used with home appliances. These batteries may burst and cause injury to persons and damage to property.

3.Use only attachments recommended or sold by manufac- turer. Use of non-recommended attachments may result in fire, electric shock, or injury.

4.When disconnecting the battery charger, pull by the plug not by the cord. Pulling on the cord may cause damage to cord or plug.

5.Locate battery power cord so it cannot be stepped on, tripped over, or subjected to damage or stress.

6.Do not operate charger with damaged cord or plug. Have cord replaced immediately.

7.Do not operate charger if it has received a sharp blow, been dropped, or otherwise damaged in any way. Take it to a qualified professional for inspection and repair.

8.Do not disassemble charger. Take it to a qualified profes- sional when service or repair is required. Incorrect reas- sembly may result in electric shock or fire.

9.To reduce risk of electric shock, unplug charger from outlet before attempting any maintenance or cleaning.

10.Do not use an extension cord unless absolutely neces-

sary. Use of an improper extension cord could result in fire or electric shock. If an extension cord must be used, make sure that:

●Pins on plug of extension cord are the same num- ber, size, and shape as those of plug on charger.

●Extension cord is properly wired and in good elec- trical condition.

●Wire size is large enough for AC ampere rating of charger, as specified below:

Length of cord (feet):

25

50

100

150

 

 

 

 

 

 

AWG size of cord:

18

18

16

14

 

11.Always charge battery in a well ventilated area.

NEVER operate in a closed-in or restricted area without adequate ventilation.

WARNING: Risk of explosive gas.

12.Locate charger as far away from battery as DC charger cables permit.

13.Do not expose charger to rain or snow.

14.NEVER charge a frozen battery. If battery fluid (electrolyte) is frozen, bring into a warm area to thaw before charging.

15.NEVER allow battery acid to drip on charger when reading specific gravity or filling battery.

16.NEVER set a battery on top of charger.

17.NEVER place charger directly above battery being charged. Gases from battery will corrode and damage charger.

18.NEVER touch the battery clips together when the charger is energized.

19.NEVER crank engine with charger attached to battery.

• IMPORTANT SAFETY INSTRUCTIONS •

• SAVE THESE INSTRUCTIONS •

00-99-000165/0103

1

Page 2
Page 1
Image 1
Schumacher important safety instructions Model MKC-10, AMP 12 Volts, Battery Charger, General Battery Safety
Page 2

MKC-10 specifications

The Schumacher MKC-10 is a state-of-the-art automatic battery charger designed to meet the demands of modern automotive batteries. With a plethora of features and advanced technologies, this charger stands out in the competitive market of battery maintenance tools.

At the heart of the Schumacher MKC-10 is its intelligent microprocessor technology. This feature allows the charger to automatically adjust its charging mode based on the battery's needs, ensuring optimal charging efficiency and prolonging battery life. It can handle both 6V and 12V batteries, making it versatile for a wide range of vehicles, including cars, trucks, motorcycles, and RVs.

One of the defining characteristics of the MKC-10 is its multi-stage charging process. The charger employs four distinct charge stages: initialization, bulk charge, absorption, and float charge. This process ensures that the battery is charged quickly but safely. The initialization stage checks the battery condition, the bulk charge stage provides maximum current, the absorption stage allows the battery to reach full capacity without overcharging, and the float charge stage maintains the battery at an optimal level.

The MKC-10 is equipped with a robust LED display that provides real-time status updates throughout the charging process. Users can easily monitor the progress, as the display indicates the charging stage, battery condition, and any errors in the process. This user-friendly interface simplifies operation, making it accessible even for those who may not be technologically savvy.

Safety features are paramount in the design of the Schumacher MKC-10. It includes reverse polarity protection to prevent accidental damage, short circuit protection, and overcharge protection, ensuring a safe charging experience. The charger's compact and portable design makes it easy to store and transport, ideal for both home use and professional applications.

Finally, the Schumacher MKC-10 is built to last, with rugged construction that can withstand the rigors of automotive environments. Whether for personal use or in a commercial garage, this battery charger combines advanced technology with practical features, making it a go-to choice for battery maintenance. With the MKC-10, you can ensure your batteries are always ready to perform, providing peace of mind and convenience.
Top Page Image Contents