Schumacher owner manual Model PS-2100MA, Reading Meters PS-1022MA, Fully Discharged Battery

MODEL PS-2100MA:

Two switches permit Battery Type and Charge Rate selection.

Switch #1 permits selection of either regular battery in automatic operation or Deep- cycle battery in automatic operation. If you are not sure of your battery type, use the regular battery setting.

Switch #2 (4 Charge Rate Modes)

Mode 1– Select 15 Amp, 6 Volt Manual Operation to charge medium and large size wet-cell, lead-acid, 6 Volt batteries. Do not charge small batteries such as used in motorcycles, lawn and garden equipment.

Manual Operation. Monitor frequently while charging a battery. Not doing so may cause damage to your battery or result in other property damage or personal injury.

Mode 2 – Select the 2 Amp automatic setting to charge small 12 Volt batteries (31 Ah or less) or to warm larger lead-acid batteries.

Mode 3 – Select 15 Amp automatic for larger 12 Volt batteries for a faster charge. Mode 4 – Select 100 Amp Engine Start to assist in engine cranking of 12 Volt systems.

DO NOT use on 6 Volt systems. Use the 100 Amp Engine Start position for cranking automobiles or light trucks.

NOTE: Use only with battery in the vehicle. This will reduce the chance of damaging sensitive electronic equipment in the vehicle.

(SWITCH #1)			(SWITCH #2)
BATTERY TYPE SELECTOR		CHARGE RATE SELECTOR
CONVENTIONAL	MAINTENANCE-	15 A, 6 V	2 A	15 A	100 A, 12 V
AND LOW	FREE AND	MANUAL	12 V AUTOMATIC		ENGINE START
MAINTENANCE	DEEP-CYCLE

11.READING METERS PS-1022MA

0 2 4 6 8 10 12

0 2 4 6 8 10 12

0 2 4 6 8 10 12

FULLY DISCHARGED BATTERY

Initial charge current to the battery is typically 10 Amp. The needle points toward the 25% mark.

APPROACHES FULL CHARGE

Charge current to the battery is typically 5 Amp. The needle points toward the 100% mark.

FULLY CHARGED BATTERY

Charge current to the battery is 0 Amp, and the Full Chargegreen LED glows. The needle points toward the Full Charge LED. (Automatic Position)

• 7 •