Schumacher SE-1010-2 Battery Charging, Charge Period, Indications of a Fully Charged Battery

K. BATTERY CHARGING

1.Before charging any battery, make sure the electrolyte (battery fluid) in each cell is at correct level. This is not required on maintenance free batteries. Read instructions on battery.

2.Set switches and or timers to Off, if the position is available. If no Off position is on your charger, set in the lowest charge rate featured usually, 2 amp.

3.If the battery is being charged inside the vehicle, use connection procedures outlined in Section E. Should the battery be removed from the vehicle, follow the instructions in Section D (step 6) and Section F. Plug the power cord into the AC outlet.

4.Set the power switch from Off (or the lowest charge rate) to the desired charge position. NOTE: This charger is a MANUAL type charger and the charging must be monitored closely to prevent overcharging of the battery.

L. CHARGE PERIOD

The approximate time required to bring a battery to a full charge state depends upon the number of ampere hours (AH’s! depleted from the battery. AH’s are determined by multiplying the number of hours time the number of amps supplied by the battery to the load For example- If a load was connected to battery which drew 7 amperes for a period of five hours, the battery will have supplied 35 AH. The approximate recharge time would be calculated by dividing 35 AH depleted from the battery, by the ampere charge rate of the charger .To allow for tapering of the charge rate add 25% to the charge time.

M.INDICATIONS OF A FULLY CHARGED BATTERY

A hydrometer reading of the specific gravity of the electrolyte (fluid) of a battery in good condition should be between 1.25 and 1.285. When a battery reaches 80-85% of full charge, bubbles will appear on the surface of the fluid As the battery nears full charge, bubbling will become more vigorous.

When the meter reaches about half the charge rate, see Meter Function, Section G.

N. ENGINE START

1.Connect the charger to the battery following instructions given in Section K.

2.Set charger to Off position, (on SE-1052 set at the 2 amp position).

3.Plug power cord into AC outlet, then move switch from Off to Engine Start. On SE-1052 move from 2 amp to Engine Start.

4.During extremely cold weather, or if the battery is fairly exhausted, charge the battery for a few minutes before you attempt the Engine Start.

5.Crank the engine by turning the ignition key.

6.If the engine fails to start, let the battery charge for another/few minutes then, try the engine start again.

O. CHARGER LOCATION PRECAUTIONS

Never place the charger directly above battery being charged, gases from battery could damage the charger.

Never allow the battery acid to drip on charger when reading specific gravity or filling battery.

Do Not operate the charger in a closed in area or restrict ventilation in any way. Keep off from carpets, seats, etc.

Do Not set the battery on top of the charger.

LIMITED WARRANTY

SCHUMACHER ELECTRIC CORPORATION, 801 BUSINESS CENTER DRIVE , MT. PROS-	than this limited warranty and expressly excludes any implied warranty including any warranty
PECT, IL 60056-2179, MAKES THIS LIMITED WARRANTY TO THE ORIGINAL PURCHASER	for consequential damages.
AT RETAIL OF THIS PRODUCT. THIS LIMITED WARRANTY IS NOT TRANSFERABLE.	This is the only express limited warranty and the manufacturer neither assumes nor authorizes
Schumacher Electric Corporation warrants this battery charger for 2 years from date of purchse	anyone to assume or make any other obligation towards the product other than this express
at retail against defective material or workmanship. If such should occur, the unit will be re-	limited warranty. The manufacturer makes no warranty of merchantability or fitness for pur-
paired or replaced at the option of the manufacturer. It is the obligation of the purchaser to	pose of this product and expressly excludes such from this limited warranty. Some states do
forward the unit together with proof of purchase, transportation and / or mailing charges pre-	not allow the exclusion or limitation of incidental or consequential damages or length of im-
paid to the manufacturer or its authorized representative. This limited warranty is void if the	plied warranty so the above limitations or exclusions may not apply to you. “This warranty
product is misused, subjected to careless handling, or repaired by anyone other than the	gives you specific legal rights, and you may have other rights which vary from state to state.”
factory or other authorized factory representative. The manufacturer makes no warranty other

6