Schumacher SWI-1555A owner manual Grounding and AC power cord connections, Assembly Instructions

7.3Connect the POSITIVE (RED) charger clip to the POSITIVE (POS, P, +) post of the battery.

7.4Position yourself and the free end of the cable you previously attached to the NEGATIVE (NEG, N, -) battery post as far away from the battery as possible – then connect the NEGATIVE (BLACK) charger clip to the free end of the cable.

7.5Do not face the battery when making the final connection. As stated in 7.4, face away from the battery when connecting the negative clip to the cable.

7.6Connect charger AC supply cord to electrical outlet.

7.7When disconnecting the charger, always do so in the reverse order of the connecting procedure and break the first connection while as far away from the battery as practical.

7.8A marine (boat) battery must be removed and charged on shore. To charge it onboard requires equipment specially designed for marine use.

8.Grounding and AC power cord connections

RISK OF ELECTRIC SHOCK OR FIRE.

8.1This battery charger is for use on either a nominal 120V, 50/60 Hz or a nominal 230V, 50/60 Hz circuit. (See the warning label on the charger for the correct input voltage.) The charger must be grounded to reduce the risk of electric shock. The plug must be plugged into an outlet that is properly installed and grounded in accordance with all local codes and ordinances.

The plug pins must fit the receptacle (outlet). Do not use with an ungrounded system.

8.2 Never alter the AC cord or plug provided – if it does not fit the outlet, have a proper grounded outlet installed by a qualified electrician. An improper connection can result in a risk of an electric shock or electrocution.

8.3If the AC cord is damaged, it must be replaced by the manufacturer, its service agent or other qualified person in order to avoid a risk of personal injury or property damage.

8.4Recommended minimum AWG size for extension cord:

•100 feet (30.5 meters) long or less - use a 14 gauge (2.5mm2) extension cord.

•Over 100 feet (30.5 meters) long - use a 12 gauge (4mm2) extension cord.

9.ASSEMBLY INSTRUCTIONS

9.1It is important to fully assemble your charger before use. Remove all cord wraps and uncoil the cables prior to using the battery charger. Follow these instructions for assembly.

	PARTS	TOOLS NEEDED
(2)	10-32, thread cutting screws	3/8" wrench (for mounting foot)
(4)	¼-20, thread cutting screws	5/16" wrench (for mounting wheels)
(4)	Phillips head sheet metal screws	hammer
(2) wheels		screwdriver (flat blade)
(1) axle		screwdriver (Phillips)
(2) axle caps
(2) axle brackets
(1) handle
(1) foot

• 36 •