Schwinn 120 manual Auto Shut-Off Sleep Mode

1.Hold down the LOCK/SCAN button and Increase button together for 3 seconds while in the POWER-UP MODE to go into the CONSOLE SETUP MODE.

2.Push the Increase/Decrease buttons to change between ELLIPTICAL and BIKE.

3.Push START/ENTER to set.

4.Push the Increase/Decrease buttons to change between ENGLISH and METRIC units.

5.Push START/ENTER to set.

6.Push Increase/Decrease to adjust the screen contrast (BACKLIGHTS; “5” = maximum intensity, “1” = minimum).

7.Push START/ENTER to set.

8.The Console shows TOTAL HOURS.

9.Push START/ENTER.

10.Push Increase/Decrease to turn motivational messages off or on.

11.Push START/ENTER to set.

12.Push Increase/Decrease to set which software version to use (“SW30 V1.0” = x20 machine, “SW40 V1.0” = x40 machine, or “NLS 514” = 514 machine).

13.Push START/ENTER to set.

Note: Push STOP/RESET for previous screen.

Auto Shut-Off (Sleep Mode)

If the Console does not receive any input in approximately 5 minutes, it will automatically shut off. The LCD display is off while in Sleep Mode.

Note: The Console does not have an On/Off switch.

12