- IMPORTANT -
Before proceeding to step 11 please complete the following steps. Failure to do so could lead to damage to the handgrip heart rate wires!
1)Remove END CAP (#11) from the end of the seat rail. The coiled wire seen above the seat rail needs to be
2)Pull the wire from the back of the seat rail until the male prong is flush with the front of the seat rail. Connect the cables from MAIN UNIT and Seat Rail. Tape can be used around the attachment of the two cable ends to ensure that they do not become disconnected.
3)Gently pull the excess cable from the back of the seat tube so that the cable running through the seat rail is taut. Be careful not to pull apart the cable connection you have just made. Slide the seat rail with seat assembly gently into the main unit, while pulling the cable tight from the back of the seat rail. Slide the seat rail slowly into the main unit. Using a flashlight check to make sure that the cable is not protruding from the bottom of the seat rail as it slides into main unit. CAUTION! If the wire is protruding from the bottom of the seat rail it may be severed or damaged when the seat rail is fully inserted into the main unit! This may result in a
Step 11: Attach SEAT RAIL (#9) to MAIN UNIT (#31) with 4, 16 mm BOLTS (#22) and 4 FLAT WASHERS (#7). Again do not tighten until after step 12. Place BOLT COVERS (23) over BOLTS (#22) in MAIN UNIT (#31).
Step 12: Attach REAR STABILIZER TUBE (#10) to BASE FRAME (#32) with 2 90mm LONG BOLTS (#24), 2 CURVED WASHERS (#19), and 2 ACORN NUTS (#20). Tighten with provided wrench. Tighten Allen bolts from steps 10 and 11 with provided Allen wrench.
Step 12b: Feed the excess coiled wire from the back end of the seat rail through the hole on top of the seat rail until about 6 inches of coiled wire is on the outside of the seat rail. Attach the end of the wire to the back of the handlebar assembly. Feed the remaining excess wire into the seat rail and replace the end cap on the end of the seat rail. After completing assembly stage 5 verify that the handgrip heart rate works by hitting manual start and then placing your hand on the grip heart pad located on the handlebars. Verify that a heart rate registers on the computer panel after several seconds.
