Schwinn Motor Scooters 50GR06BL, 50GR06SV manual Breaking In the Scooter, Riding the Scooter

Models: 50GR06SV 50GR06BL

1 20
Download 20 pages 23.39 Kb
Page 12
Image 12

Breaking In the Scooter

For the first 100 miles (160 kilometers) it is recommended that you kick start the scooter, or use the kick starter to “prime” the engine (force fuel into the carburetor) prior to using the electric starter. This preserves battery life and reduces wear to the electric starter during the break-in period.

ALWAYS allow the engine to warm up for 2 to 3 minutes before driving.

Do not drive the scooter at a constant speed for long periods of time during the break-in period. Avoid overheating the engine.

Riding the Scooter

ENTERING ROADWAYS

Apply the turn signal if needed.

Make sure there is no oncoming traffic. ALWAYS be aware of other vehicles on public roads. Many accidents are caused when drivers of cars do not see scooters who share the road.

Release the brake and gradually advance the throttle for smooth acceleration.

ACCELERATION AND DECELERATION

Adjust speed by twisting the throttle. Twist the throttle toward you to accelerate. Twist the throttle away from you to decelerate. NOTE: Your new scooter has an automatic transmission, so there is no clutch and no need to shift gears.

ALWAYS allow the engine to warm up thoroughly before hard acceleration, or damage to the engine could occur.

BRAKING

WARNING

ALWAYS apply the front and rear brakes simultaneously to slow down or come to a stop.

BE CAUTIOUS when using the front brake. Loss of traction on the front wheel can make both steering and braking ineffective. Using the front brake in loose gravel or wet road conditions can result in loss of traction.

DO NOT continually engage the brakes for an extended period of time. This causes excessive wear and can overheat the brakes, causing brake failure which could result in serious injury or death.

In wet driving conditions, be aware that normal stopping distances are increased.

PARKING

NOTE: Always park on smooth, level ground.

Turn the ignition key to the OFF position. Remove the key.

Move the engine stop switch to the OFF position.

Dismount the scooter and engage the center stand.

DO NOT park on a slope or on soft surfaces. The scooter could tip over.

DO NOT park near flammable materials.

Engage the steering lock to prevent theft (see instructions on page 6).

10

Page 12
Image 12
Schwinn Motor Scooters 50GR06BL, 50GR06SV manual Breaking In the Scooter, Riding the Scooter