Connection Diagram

Installation

Follow these steps for proper installation.

The following diagram illustrates one of the various connection options that are available to you.

1.

Power down your PC and unplug it from the

 

power source.

2.

Connect the active RF coaxial cable to the

 

connector on the back of the cable modem labeled

 

CABLE IN. Use an optional cable signal splitter

 

to add a TV, a DHCT or set-top converter, or a

 

VCR.

3.

Connect either the Ethernet port or the USB port

 

on the back of the cable modem to your PC using

 

the appropriate supplied cable.

4.

Insert the power cord into the power supply on

 

the back of the cable modem, and then plug the

 

cord into an AC power source.

5.

Plug in and power on your PC.

6.

Configure the TCP/IP protocol, or install the USB

 

drivers from the supplied diskette, whichever is

 

necessary for your system.

 

Note: See Configuring TCP/IP on pages 48

CABLE

IN

USB

Power Supply

ETHERNET

RESET

12 VDC

0.6A Max

Power

Supply

RF

Cable

Cable

Splitter

RF

Cables

Cable-Ready TV,

VCR, or Set-Top

Converter

PC

Ethernet

Cable

T9355

ENGLISH

through 50, or Installing the USB Drivers on

page 51 of this guide for further instructions.

Note: Professional installation may be available. Contact your local cable service provider for further

assistance.47