Internet Service: Configure TCP/IP, Continued
Macintosh
Follow these steps to verify that the TCP/IP communications protocol and an Ethernet device are installed on your Macintosh computer.
1.Click the Apple icon in the upper left corner of the Finder. Scroll down to Control Panels, and then click TCP/IP.
2.Click Edit on the Finder (gray bar) at the top of the screen. Scroll down to the bottom of the menu, and then click User Mode.
3.Click Advanced in the User Mode window, and then click OK.
4.Click the Up/Down selector arrows located to the right of the Connect Via section of the TCP/IP window, and then click Using DHCP Server.
5.Click Options in the TCP/IP window, and then click Active in the TCP/IP Options window.
Note: In some cases, the Load only when needed option will not appear. If it appears, select the option. A check mark appears in the option.
6.Verify that the Use 802.3 option located in the upper
7.Is there a Hardware Address listed in this window?
•If yes, click OK. To close the TCP/IP Control Panel window, click File, and then scroll down to click Close. You have completed this procedure.
•If no, you must power down your Macintosh.
8.With the power off, simultaneously press and hold down the Command (Apple), Option, P, and R keys on your keyboard. Keeping those keys pressed down, power on your Macintosh. The computer will start, and you will hear the Apple chime; do not release these keys.
9.Continue pressing these keys for up to three chimes, then release the keys and allow the computer to restart.
10.When your computer fully reboots, repeat steps 1 through 7 to verify that all TCP/IP settings are correct. If your computer still does not have a Hardware Address, contact your authorized Apple dealer or Apple technical support center for further assistance.
4004041 Rev B | WebSTAR DPX2203 or EPX2203 VoIP Cable Modem User’s Guide | 25 |