Scotts 3000 manual Set up the stand and handle, Set the spreading rate before you begin

TRIGGER CONTROL

To use your new AccuGreen® 3000TM spreader:

Set up the stand and handle

1. Lay the spreader down so that it rests on the front of the hopper. Lift the stand and brace, then spread the sides of the brace and insert the ends into the holes in the stand.

2. Place the spreader upright on its wheels. Raise the top half of the handle to the upright position and tighten the wing nuts by hand. With our patented locking wing nuts, no tools are needed.

NOTE: Reverse steps 1 and 2 for convenient, compact storage of your AccuGreen® 3000TM spreader.

Set the spreading rate before you begin

5.If the lawn product you purchased does not give the setting for

your Scotts® AccuGreen® spreader, you can test for the proper setting.

Empty the number of pounds the manufacturer recommends for 1,000 square feet (90 sq. meters) into the spreader. Adjust the spreader to a very low setting and spread product over a 1,000- square- foot (90 sq. meter) area (50 by 20 feet, 33 by 30 feet, 15 by 6 meters, 10 by 9 meters, or equivalent). Adjust the setting upward after judging how much product has been applied to the test area. Remember: it is safer to under-apply with the test and increase setting later as needed. Some fertilizers can burn your lawn if over- applied.

Follow these application tips for guaranteed results

For best results, use a Scotts Lawn Fertilizer or Grass Seed Product.

1. First check the back of your Scotts® product package for the proper rate setting number under the heading “Scotts Drop.” Some

other lawn product manufacturers provide settings for Scotts drop spreaders, but using Scotts products will assure the best possible results. (If you already purchased a product which does not provide a setting for Scotts drop spreaders, you can use the method described

in #5.)

2. Be sure spreader is turned off (trigger control is away from the handle) by rocking the lock lever(A).

3. Always fill the spreader on the driveway or sidewalk — not on the lawn. Turn the

micrometer rate setting barrel (B) until the proper number is visible in the window.

4.Ready? Start walking, then squeeze the trigger to open the spreader (C). You may lock the spreader in the “on” position by rocking the lock mechanism into place.

Always push the spreader when applying product. When pulled backward while open, the spreader may apply an excessive amount and damage the lawn.

LOCK LEVER

(A)

(B)

(C)

1. If your lawn is rectangular, apply product the longest direction. Apply two header strips across each end for a turning area. Do not leave the spreader open as you turn — shut it off as you reach the end of a strip, then open it as you begin the next one.

If there are trees in the lawn, shut off the spreader just before getting to the trunk, then

move to the opposite side and continue with the spreading pattern.

2. If your lawn is an irregular shape, apply a head- er strip completely around it. Then apply prod- uct back and forth in the longest direction, shutting off the spreader when you reach the header strip.

3.Avoid “skips” or missed streaks. This means

slightly overlapping each strip over the edge
of the previous strip by lining up the arrow
on the hopper with the wheel track from the
previous row. Do not use the wheel for
alignment.
TIP: Applying a slight amount of water to
your lawn prior to using the spreader will	ARROW
highlight your rows, making consistent	WHEEL TRACK FROM
	WHEEL TRACK FROM
application easier.	PREVIOUSPREVIOUSROWROW