Seagate 18FC manual

Cheetah 18FC Installation Guide, Rev. A 3

peratures are usually highest.

•Follow the precautions listed above in “Electrostatic discharge protection.”

•Do not remove any circuit boards from the drive chassis. Return the entire drive for depot repair if any circuit board is defective. Removal of circuit boards by personnel not perform- ing depot repair will damage components and may void the warranty.

•Do not remove the head and disc assembly (HDA) from the drive. Return the entire drive for depot repair if the HDA is defective.

•Do not attempt to disassemble the HDA. It is not field repair- able. If the sealed HDA is opened by personnel not performing depot repair, this will damage components and void the war- ranty.

As a component, the drive is designed to be installed and oper- ated in accordance with UL1950, EN60950, CAN/CSA C22.2 950-95, VDE0805 and IEC950.

Seagate takes all reasonable steps to ensure that its products are certifiable to currently accepted standards. Typical applica- tions of these disc drives include customer packaging and sub- system design. Safety agencies conditionally certify component assemblies, such as the Barracuda disc drive, based on their final acceptability in the end-use product. The subsystem designers are responsible for meeting these conditions of acceptability in obtaining safety-regulatory agency compliance in their end-use products and for certifying where required by law. A necessary part of meeting safety requirements is the provision for overcurrent protection on drive SELV supply voltages.