Seagate ST136475LW/LC manual Drive models, General information

Barracuda 36 Installation Guide, Rev. B 19

Initial setup information

The general information beginning on this page applies to all of the Barracuda 36 drive models. After reading the general infor- mation topics, refer to the appropriate drive-specific section listed below for additional information about configuring and installing your particular model.

Drive models	Page
ST136475LW	39
ST136475LC	44

General information

The following general information topics are discussed:

•SCSI ID jumpers

•Drive termination

•Terminator power

•Interface drivers and data path width notes

•Other applicable jumper options

•Providing adequate cooling

•Mounting the drive and connecting cables1

•Formatting the drive

1This mounting procedure does not apply to “LC” model drives. To mount an “LC” drive, plug the drive into the system’s single connector attachment (SCA) position on the system’s back panel.