Hawk 2LP (Wide) Installation Guide, Rev. A | 31 |
continued from previous page
| I/O pin 26 to the drive's internal termina- |
| tors (for |
Off | See above explanations for TP jump |
| ers. |
| |
Jumper | Jumper Function Description ("W" |
Installation | and "WD" models only) |
A3,A2,A1,A0 | Drive ID on SCSI Bus |
| may be used, as the ID circuits are wired |
| in parallel). The drive ID is binary coded |
| positionwise i.e. jumper in position A3 is |
| drive ID 8, A2 is drive ID 4, position A1 is |
| ID 2, position A0 is ID 1 and no jumpers |
| is ID 0. Default is ID = 0. Both J1- |
| auxiliary and J6 should not be used at |
| the same time, because at some future |
| time when the ID is changed the user |
| could fail to configure both |
| and J6 the same. "WC" and "DC" Mod- |
| els, do not have |
J6 Jumper | Jumper Function Description ("W" |
Installation | and "WD" models only) |
A3,A2,A1,A0 | Drive ID on SCSI bus. Either J6 or J1- |
| Auxiliary (optional) may be used to |
| select drive ID. Both should not be used |
| at the same time, because at some |
