Cheetah 36XL Product Manual, Rev. E | 39 |
8.0Installation
Note. These drives are designed to be used only on
The first thing to do when installing a drive is to set the drive SCSI ID and set up certain operating options. This is usually done by installing small shorting jumpers on the pins of connectors J2 and J6 on the PCBA (or J1- Auxiliary on the LW model), or via the drive to host I/O signals on the LC model. Some users connect cables to J6 or
Configure drive options
For option jumper locations and definitions refer to Figures 16, 17, and 18. Drive default mode parameters are not normally needed for installation. Refer to Section 9.3.2 for default mode parameters if they are needed.
•Ensure that the SCSI ID of the drive is not the same as the host adapter. Most host adapters use SCSI ID 7 because ID 7 is the highest priority on both 8 and 16 bit data buses.
•If multiple devices are on the bus set the drive SCSI ID to one that is not presently used by other devices on the bus.
•If the drive is the only device on the bus, attach it to the end of the SCSI bus cable. The user, system integra- tor, or host equipment manufacturer must provide external terminators.
Note. For additional information about terminator requirements, refer to Sections 9.8 and 9.9.
•Set all appropriate option jumpers for desired operation prior to power on. If jumpers are changed after power has been applied, recycle the drive power to make the new settings effective.
•Installation instructions are provided by host system documentation or with any additionally purchased drive installation software. If necessary see Section 10 for Seagate support services telephone numbers.
•Do not remove the manufacturer’s installed labels from the drive and do not cover with additional labels, as the manufacturer labels contain information required when servicing the product.
Formatting
•It is not necessary to low level format this drive. The drive is shipped from the factory low level formatted in 512 byte sectors.
•Reformat the drive if a different spare sector allocation scheme is selected.
•High level formatting the drive involves assigning one or more partitions or logical drives to the drive volume. Follow the instructions in the system manuals for the system into which the drive is to be installed.
