![](/images/new-backgrounds/1206821/20682169x1.webp)
6.4.4.2Vibration
a.
The drive as installed for normal operation, shall comply with the complete specified performance while subjected to continuous vibration not exceeding
5 - 500 Hz @ 0.5 G (0 to peak, swept sine, 1.0 octive/min) Vibration may be applied in the X, Y, or Z axis.
b.
Equipment as installed for normal operation shall not incur physical damage while subjected to periodic vibration not exceeding:
15 minutes of duration at major resonant frequency
Vibration occurring at these levels may degrade operational performance during the abnormal vibration period. Specified operational performance will continue when normal operating vibration levels are resumed. This assumes system recovery routines are available.
Operating abnormal translational random flat profile
5 - 500 Hz | 0.75 G (0 to peak) |
c.
The limits of
The drive shall not incur physical damage or degraded performance as a result of continuous vibration not
exceeding |
|
|
5 - 22 Hz | 0.25 G (0 to peak, linear, swept sine, 0.5 octive/min) | |
22 - 350 Hz | 5 | G (0 to peak, linear, swept sine, 0.5 octive/min) |
350 - 500 Hz | 1 | G (0 to peak, linear, swept sine, 0.5 octave/min) |
Vibration may be applied in the X, Y, or Z axis.
6.4.5Acoustics
Sound power during idle mode shall be 3.6 bels typical when measured to ISO 7779 specification. Sound power while operating shall be 4.0 bels typical when measured to ISO 7779 specification.
There will not be any discrete tones more than 10 dB above the masking noise on typical drives when mea- sured according to Seagate specification
6.4.6Air cleanliness
The drive is designed to operate in a typical office environment with minimal environmental control.
6.4.7Corrosive environment
Seagate electronic drive components pass accelerated corrosion testing equivalent to 10 years exposure to light industrial environments containing sulfurous gases, chlorine and nitric oxide, classes G and H per ASTM B845. However, this accelerated testing cannot duplicate every potential application environment.
Users should use caution exposing any electronic components to uncontrolled chemical pollutants and corro- sive chemicals as electronic drive component reliability can be affected by the installation environment. The sil- ver, copper, nickel and gold films used in Seagate products are especially sensitive to the presence of sulfide, chloride, and nitrate contaminants. Sulfur is found to be the most damaging. In addition, electronic components should never be exposed to condensing water on the surface of the printed circuit board assembly (PCBA) or
Cheetah NS SAS Product Manual, Rev. B | 29 |