Seagate ST39140N/W/WC/LW/LC Initial setup information, General information, Drive models, Page

22 Medalist Pro Installation Guide, Rev. B

Initial setup information

The general information beginning on this page applies to all of the Medalist Pro drive models. After reading the general informa- tion topics, refer to the appropriate drive-specific section listed below for additional information about configuring and installing your particular model.

Drive models			Page
ST39140N	ST36530N	ST34520N	42
ST39140W/LW	ST36530W	ST34520W/LW	46
ST39140WC/LC	ST36530WC	ST34520WC/LC	52

General information

The following general information topics are discussed:

•SCSI ID jumpers

•Drive termination

•Terminator power

•Interface drivers and data path width notes

•Other applicable jumper options

•Providing adequate cooling

•Mounting the drive and connecting cables1

•Formatting the drive

1This mounting procedure does not apply to “WC” or “LC” model drives. To mount “WC” or “LC” drives, plug the drive into the system’s single connector attachment (SCA) position on the system’s back panel.