Seagate ST39140N/W/WC/LW/LC, ST36530N/W/WC, ST34520N/W/WC/LW/LC Mounting configuration dimensions

40	Medalist Pro Installation Guide, Rev. B
C [3]	G
[1]	D
E	F
	A [3]
	Notes:

[1]Mounting holes three on each side, 6-32 UNC. Max screw length into side of drive 0.15 in. (3.81 mm). Screw tightening torque 6.0 in-lb (.675 NM) max with minimum thread engagement of 0.12 in. (3.05 mm).

[2]Mounting holes four on bottom, 6-32 UNC. Max screw

B

length into bottom of drive 0.15 in. (3.81 mm). Screw tightening torque 6.0 in-lb (.675 NM) max with minimum thread engagement of 0.12 in. (3.05 mm).

K

[2]

[3]Power and interface connectors can extend past the “A” dimension by 0.040 in. (1.02 mm).

J		[4]	Centerline of pad for Pin 1 of power connector.
	[4] L
		[5]	Centerline of pad for Pin 1 of J6.
		[6]	Centerline of pad for Pin 1 of J2. Dimensions indicated are
			for reference only.
		[7]	Dimensions to Pin 1 of each connector are nominal values.

M [6]

J2

[6] N

H

S [8]

J6LED

P [5]

R

[8]To pin ends on J6. Pin ends on J6 are nominally flush with end of drive.

[9]Although the illustration shows the 50 pin I/O connector drive model, mounting hole locations are the same for all Medalist Pro models.

Dimension Table

	Inches		Millimeters
A	5.787	± .010	146.99	± .25
B	4.023	± .010	102.2	± .25
C	1.28	+ .021	26.9	+ .53
		– .009		– .22
D	2.362	± .010	60.00	± .25
E	1.120	± .020	28.45	± .51
F	4.000	± .010	101.60	± .25
G	.250	+ .010	6.35	+ .25
		– .005		– .12
H	1.750	± .010	44.45	± .25
J	3.750	± .010	95.25	± .25
K	1.625	± .020	41.28	± .51
L	0.143		3.63
M	0.260		6.60
N	0.061	[7]	1.55	[7]
P	0.405		10.29
R	2.265		57.53
S	2.350		59.69

Figure 6. Mounting configuration dimensions