U-Line Complete Guide for Ice Maker with Key Troubleshooting for Models U-CLR2160B and U-CLR2160S

NOTICE

•Discard all ice produced in the first harvest.

•Should power to the unit be interrupted during the self-clean cycle, it will be necessary to repeat the complete cleaning cycle after power is restored.

Refresh Kit

Due to variations in water quality or inadequate maintenance your unit may become excessively coated in lime scale or calcium. U-Line offers a cost effective refresh kit which replaces many interior components and will return your unit to like new condition. Refresh kits may be ordered from your local distributor and installed by your local service company. For information on your local distributor or service company please visit http://www.u-lineservice.com.

Refresh Kit Part Number

Model	Part Number
CLR2160	80-51003-00
CLRCO2175	80-51002-00

Ice Cube Thickness Adjustment

Interval - As Required

Ice thickness adjustments are made using the control panel as follows:

1.To enter the thickness adjustment mode:

•Touch and hold WARMER .

•Touch and release COOLER three times, then release

WARMER .

•The display will switch to “0” to confirm the thickness adjustment mode has been selected.

2.The factory setting is “0,” and the total range of adjustment is -5 to +5 (ideal range is -1 to +1). Use WARMER to raise the setting and thicken the ice bridge, or COOLER to lower the setting to thin the ice bridge.

Ice cubes in any given batch will vary, so it is necessary to choose cubes from the sample area for comparison when making adjustments. If further adjustments are desired, repeat Steps 1 through 4.

The ice cube thickness is factory set for best overall performance. The factory setting is designed to maintain an ice bridge of approximately 1/16" to 1/8" under normal conditions, resulting in a dimple of approximately 1/4" to 1/2" in depth. A fuller cube with less of a dimple results in a thicker ice bridge. As the ice bridge becomes thicker, the tendency for the cubes to stay together as a slab increases. A bridge thicker than 1/8" may cause cubes to overfill the ice bucket.

DIMPLES

ICE BRIDGE

Ice Bridge and Dimples

	Cube Types
1/4" TO 1/2"		1/16" TO 1/8"
DIMPLE		ICE BRIDGE

NOTICE

Ice thickness adjustment should only be made one increment at a time. Allow ice maker production to stabilize for 24 hours before rechecking ice thickness.

3.Touch and release the LIGHT button key to exit the ice thickness adjustment mode.

4.Remove all ice from the storage bin.

		GOOD
	BRIDGE		BRIDGE
	TOO THIN		TOO THICK
DIMPLE			LITTLE OR
TOO DEEP			NO DIMPLE

BAD

u-line.com 7