U-Line U-CLR2160S-01 Leveling, Removing and Installing Interior Shelves, Light Bulb Replacement

Maintenance

Leveling

NOTICE

Unit must be level, for proper door and ice maker (if equipped) operation.

1

For Models with adjustable leveling feet:

1.Use a level to check the levelness of the unit from front to back and from side to side. Place the level along top edge and side edge as shown (1).

2.If the unit is not level, rotate the adjustable leveling legs to raise or lower each corner of the unit as necessary.

3.Check levelness after each adjustment and repeat the previous steps until the unit is level.

For Models without adjustable leveling feet:

NOTICE

The unit must be located on a level surface, for proper door and ice maker (if equipped) operation.

Use a level to check the levelness of the unit from front to back and from side to side. Place the level along top edge and side edge as shown (1).

Removing and Installing Interior Shelves

1.Pull shelf out about 6" until back of shelf clears the “hump” on the right-hand side.

2.Tilt right-hand edge of shelf

up. Remove shelf from unit by pulling out.

Insert the shelves as follows:

1. To move to a different	2
	1
position in the unit, insert
shelf at an angle,
approximately 15°-20° over
the rib in the side of the unit
where you want to place the
shelf. The shelf must be
started into the unit at an
angle to clear the door.

2.Continue to slide the shelf

into the unit at an angle until free.

3.Lower the shelf and push it in completely.

Light Bulb Replacement

CLRCO2175 Only

To replace the light bulb in your U-Line unit:

1.Find the light located at the top of the unit. Grasp the edges of the light housing lens (1), opposite the exposed tab, and gently push the lens toward the tab (2).

2.Pull the edge of the lens down (1) and swing it out of the light housing.

2

1

NOTICE

ALWAYS use a genuine U-Line replacement 120V 10 watt bulb (Part Number 31317) in the light housing. Use of any other bulb within the housing will produce excessive heat, causing damage to the light housing and cabinet interior, and will compromise the precise temperature control of the unit.

3.Replace the lens by first inserting the tab side back into the housing at a slight angle.

4.While gently pushing the lens towards the tab end, push the free end into the housing, and release when you hear a snap.

8 u-line.com