SeaLand 111 Table of Contents, Important Information, Toilet Model Identification, How to Use

Table of Contents

Important Information	2	Dimensional Specifications	4
Toilet Model Identification	2	Deodorants and Special Tissue	5
How to Use	2	Service Tip	5
Installation	3	Troubleshooting Guide	6 - 7
Pedestal and Pedal Cover Installation	3	Ordering Parts	8
Proper Bowl Cleaning	4	Customer Service	8
Winterizing	4	Warranty	8

Important Information

1.Do not use chlorine or caustic chemicals, such as laundry bleach or drain-opening types, in the system. These products damage the seals in toilets and dump valves.

2.Do not permit foreign objects (paper towels, paper cups, diapers, sanitary napkins, etc.) to be flushed through the toilet.

3.Mechanical seal toilets, like SeaLand units, are designed to only discharge directly into a holding

tank. Horizontal pipe runs as found in conventional residential or commercial plumbing systems cannot be accommodated.

4.Toilet must be regularly cleaned and winterized according to “Proper Bowl Cleaning” and “Winterizing” procedures on page 4, or your warranty coverage may be voided.

Toilet Model Identification

The model identification label is located on the toilet base and will show the model number and serial number. Follow instructions for removing toilet pedestal cover in “Pedestal and Pedal Cover Installation” on page 3. If label is not available, please refer to “Dimensional Specifications” on page 4 for toilet model identification.

DOMETIC CORPORATION

P.O. BOX 38, 13128 STATE RT 226 (800) 321-9886 BIG PRAIRIE, OH 44611 USA

MODEL NO. 000

SERIAL NUMBER

000000

How to Use

To prepare the SeaLand toilet for use, make sure water supply to the toilet is connected. Turn on water supply and check system for leaks. Flush toilet and check again for leaks.

Make sure the flushing instruction label (shown at right) is in plain sight and easy for guests to read. If this label is not included in this manual, please contact the

SeaLand Product Customer Service Department immediately.

To properly use the SeaLand toilet, follow these simple instructions:

1.To add water to the toilet, lift or raise the flush lever until desired water level is reached. Generally, more water is required only when flushing solids.

2.To flush toilet, push lever all the way down until contents leave toilet

bowl. Water flow pressures vary at different locations, therefore holding the flush lever down for 4-8 seconds may be required. We require a minimum flow at the inlet of the toilet of 2 gpm (7.6 lpm) for proper flushing.

3.Allow flush lever to snap back, which permits positive sealing around the flush ball.

4.A small amount of water should remain in bowl.

Note: Holding flush lever down longer than necessary results in excessive water usage.