SeaLand 1 2500 Series Operation, Display Panel, Start-Upchecklist, Flushing The Toilet

OPERATION

DISPLAY PANEL.

GREEN – Ready to flush.

RED – Cassette full, or cassette

LED removed, or undervoltage.

Toilet cannot be flushed.

YELLOW – Vacuum pump is running.

Do not flush toilet.

START-UP CHECKLIST

Before first-time use of the 2500 series sanitation system, check the following:

•The vacuum cassette tank is inserted correctly.

•The fresh water supply tank is full.

•The power supply is on.

The yellow LED illuminates for about one minute. Then the green LED illuminates. THE SYSTEM IS READY FOR OPERATION.

FLUSHING THE TOILET
1.	Make sure there is enough water in the bowl to	4. Use only rapid-dissolving toilet paper designed
	cover the flush ball and seal in bottom of bowl. Lift	for low water flow toilets. Some residential bath
	pedal to add water to bowl (if needed for flushing	tissues may clog the system.
	solids).	Flush toilet only when
2.	To flush, press pedal down to floor and hold down
	for 2 or 3 seconds. Keep seat lid closed to reduce	green LED is illuminated.
	noise.

3.The toilet will flush liquids effectively with only 1 pint (0.4 liters) of water per flush.

Never flush toilet while sitting on open toilet seat, or if the seat lid is up.

Do not flush any solid or non-dissolving objects such as paper towels, plastic cans. They can plug or damage system.

5.If the cassette tank is full, the tank is removed from the docking platform, or the voltage is too low, the red LED illuminates and the system switches off. The system cannot be used until the cassette is emptied, inserted properly in the docking platform, and the correct voltage is restored.

REMOVING CASSETTE TANK (model 2510)

1.Raise the latch (A). Holding the carrying handle (B), pull cassette straight back.

2.When reattaching cassette tank, make sure it is placed correctly on docking platform. Make sure latch engages after pushing tank into platform.

A

B

8