8.Disconnect freezerdoor bottom hinge water line by disconnecting the 1/4" OO_ plastic tube union nut, Slide the compression nut off the water tube See Figure 11.
14.Lift refrigerator door up to pull pin up off the hinge.
15Thread wires through slot in door hinge See Figure 13 Hinge pin and door closures stay attached to
the door,
TO DISCONNECT WATER TUBE
FIGURE 13
REMOVE THE TUBE
"CLAMP SCREW REMOVI
DISCONNECT TRIS PLASTIC UN_ON |
| |
AND PULL | THE TUBE |
|
THROUGH | THE CLAMP | 16. |
|
| |
FIGURE 11
9.Mark around the upper hinge brackets with a pencilto locate them {or reassembly.
{emove the upper door hinges, (3) three screws per upper hinge. See F_gure10.
[ CAUTmON
To Avoid The Risk Of Personal injuryOr Property Damage have two peop{e remove the door,,One to hold the door and one to
remove the safety tape, and help with the tools.
11, Remove tape from top of freezer.
12.The freezer door water _inewill thread through the bottom hinge, lift the door off carefully See Figure 12
FIGURE It
FREEZERDOOR
R TUBE UNION
FIGURE 12
LOWER HINGE BRACKE T
CAUTION
To Avoid The Risk Of Property Damage set refrigerator door down carefully to avoid dam- aging electrical wires.
NOTE: At this point, the refrigerator may fit through the doorway, If not, proceed to steps 17 and 18.
17Mark around the lower hinge brackets with a pencil.
18.Remove the lower hinge bracket
screws. (2) screws per lower hinge° See Figure 14.
FIGURE 14
\4
OCKET WRENCH TO \_
REMOVE AND iNSTALL
HINGE SCREWS
IkWARNING:
TO AVOID RISK OF ELECTRICAL
SHOCK, PERSONAL INJURY OR
DEATH, THE GROUND WIRES
MUST BE CONNECTED WHEN THE
DOORS ARE REASSEMBLED,
13. Remove tape from top of | 'Toinstall the door assemblies, |
refrigerator door. | assemble in reverse order, |
|
