
packing and Door
CAUTION
To Avoid The Risk Of Personal
Injury, Use Caution In Unpacking,
Handling, Removing, Installing
and Cleaning All Parts Of Product
Which May Have Sharp Edges.
ACAUTION
To Avoid The Risk Of Personal
Injury, Wear Protective Hand
Covering.
Remove all tape and packing material To remove tape residue, touch a portion of the tape to the residue and lift it off If adhesive residue still remains, try clean- ing the sticky area with a clean cloth soaked in mild dish washing soap. Wipe
area clean_
if the wood base is still attached, have snmeone help you tilt the unit onto its k, placing a sturdy support under-
._th.Remove the mounting bolts from the base and discard bolts and wood base,
IMPORTANT! Do not leave the cabinet
on itsback longer than it takes to remove the wooden base and do not
connect the power cord until after all the inside packing has been removed and the cabinet has been leveled for proper operation.
IMPORTANTI
Must Install the Defrost Pan As Shown
Sound Reducing Cone
Locating
Stops
Grille
Defrost
n Pan
Located Bottom Right Side.
With the unit upright, pull the grille from the bottom front and make sure the
'"frost drain pan is located underneath defrost water drain tube. Two drain
'_'panside supports (attached to the cabF
net bottom) keep the pan in the proper location, to make the automatic defrost
drain water drop on the sound reducing cone. The drain pan locating stops pre-
Handtle Removal
vent the pan from being installed backwards.
Remove all tape and packing material from inside the unit
SPECIAL NOTE: If Cabinet is unable to
fit through doorway safely, you may have to remove the door handles or
door assemblies Refer to the following chart and diagrams.
To Remove Door Handles
WARNING
To Avoid The Risk Of Personal Injury, Property Damage Or Death
unplug the refrigerator before attempting to remove the door handle&
REMOVE THE FREEZER TOP DOOR EDGE TRIM PIECE. Remove the screws holding the trim to the top of the door. See Rgure 1, Remove the top door edge trim by sliding the top door edge trim to the right and lifting up. See Figure 2
Trim
I
Face Trim
FIGURE1
FIGURE 2
2oREPLACE TWO SCREWS. Tempo- rarily replace two screws to hold the
second trim strip underneath. DO NOT REMOVE THE SECOND TRIM
STRIP FROM THE DOOR_ See Figure 3o
FIGURE 3
3.REMOVE THE TOP HANDLE CAR Push upward to unsnap the handle cap from the track in the base of the handte. Hold cap to prevent it from
dropping once free from the handle track° See Hgure 4.
FIGURE 4 | __" |
, CAUTION
To avoid the risk of property dam- age DO NOT kink the trim strips.
REMOVE THE HANDLE TRIM STRIR Remove the trim strip from the handle track. Bend the strip gen-
tly if necessary, to clear the ceiling. DO NOT KINK. See Figure 5.
FIGURE 5 i _/
ACAUTION
To Avoid Personal Injury, securely hold onto the door handles while
removing screws.
5REMOVE THE HANDLE, Unscrew the seven exposed handle mounting screws See Rgure 6.
FIGURE 6
6.Handles wilt easily fall away
7.Repeat process for refrigerator door.
8oThe electronic keypad is electrically
connected to the refrigerator door face trim piece. Use care in handling so as not to pull the electrical connection