Caster/Caster Foot Assembly
1.Remove the power assembly from the dust drum and set aside.
2.Turn the dust drum upside down on the floor.
3.Insert the caster feet into the bottom of drum, as shown (4 places).
4.Push on the caster foot until the foot is flush with bottom of the dust drum.
5.Insert the caster stem into the socket of the caster foot, as shown (4 places).
6.Push on the caster until the ball on the caster stem is inserted all the way into the socket. You will hear the ball snap into the socket and the caster will swivel easily when positioning is correct.
7. Turn the drum upright.
_.,_ |
| Caster | Stem |
Caster | _.I_ | Caster | Ball |
|
|
| |
Foot |
|
|
|
Dust Drum
Vac Assembly
1.Line up vacuum port in power assembly with drain cap located on the front of the drum.
2.Place power assembly on top of drum
with the handles snug against the drum channel.
3.Be sure power assembly completely covers the top of the drum so leakage
Drum
Lid_
Handle
\
Stop
Tab
does not occur.
4.Push down on top of the handles to cause the flexible locking tabs to hook onto the drum lip of the channel.
5.Make sure that the locking tabs are snapped in place to prevent the power assembly from coming off. (See inset below)
Push
Down
Pull
Out
Flexible
Locking
Tab
Do Not Force Flexible
Tab Beyond Stop Tab
Drum
Outexible Locking Tabs
