Sears 200.713101

Your batterycharger can be used to jump start your car ifthe batteryis low. Follow

these instructionson how to use the ENGINESTART feature.

1. Connect thechargerto the batteryand

vehicleas instructedinthe "Charging

yourbattery"section onpage 8.

2. Setthe righthand SELECTOR

SWITCHonENGINESTART.

,Crank the engine for no more than 5

seconds. If it does not start, wait at

least 4 minutes before cranking

again. In extreme cold or if the battery

is severely discharged, charge the

battery in the 10 amp position for about

5 minutes before cranking the engine.

4. After the engine starts, unplug the

charger power cord from the AC

outlet. Then disconnect the charger

from the battery.

IMPORTANT: Do not try to start the

engine without a battery in it. You could

cause damage to the electrical system.

Ifthe engine does turn over, but never

starts up, there is no problem with

the starting system, but there is a

problem somewhere else in the vehicle.

STOP cranking the engine until the