Sears 200.71990 manual To order and replace jaws

5.to order and replace jaws

Part Number	Description	QTY Per Clamp
2299001580	Kit, Battery Clamp Rebuild	1

5.1Battery Clamp Jaw Replacement

•Secure clamp in open position using a vise or equivalent clamping device. IMPORTANT: Make sure the rotary switch on the front panel is in the O (OFF) position and the jump starter is not plugged into a 110V AC electrical wall outlet.

•Unscrew fastener securing the cables to the rear of the top jaw.

•Unscrew fasteners (2) securing the Copper Jaws to the plastic clamp. Remove the jaws and braided cable.

•Reverse for assembly.

6.storage and maintenance important:

•charge immediately after purchase

•keep fully charged.

Charge the internal battery immediately upon purchase, every 30 days and after every use.

All batteries are affected by temperature. The ideal storage temperature is at 70 degrees Fahrenheit. The internal battery will gradually self-discharge (lose power) over time, especially in warm environments. Leaving the battery in a discharged state may result in permanent battery damage. To ensure satisfactory performance and avoid permanent damage, charge the internal battery every month.

When the jump starter is ON, the clamps are live and will produce arcing or sparking if they come in contact with each other. To prevent accidental arcing, always keep the clamps on the storage holders and the JUMP START ON/OFF switch in the OFF position when not using it to jump start a vehicle.

• 4 •