20
SERVICE AND MAINTENANCE
Remove the frame cover from the underside of the snow thrower
by removing four self-tapping screws which secure it. See Figure
22.
Remove the belt as follows. Refer to Figure 23.
a. Loosen and remove the shoulder screw which acts as a belt
keeper.
b. Unhook the support bracket spring from the frame.
7. Remove the belt from around the auger pulley, and slip the belt
between the support bracket and the auger pulley. See Figure 24.
8. Reassemble auger belt by following instructions in reverse order.
NOTE: Do NOT forget to reinstall the shoulder screw and reconnect
the spring to the frame after installing a replacement auger belt.
Drive belt
To remove and replace your snow thrower’s drive belt, proceed as
follows:
Place a piece of plastic under the gas cap.
Remove the plastic belt cover on the front of the engine by remov-
ing the two self-tapping screws. See Figure 20 on previous page.
5.
6.
1.
2.
Figure 22
Figure 23
Figure 24
AB