ASSEMBLY
5.Finish securing chute control assembly to chute support bracket with wing nut and hex screw removed earlier. See Figure 4.
6.Check that all cables are properly routed through the cable guide on top of the engine. See Figure 5.
7.The extension cord is fastened with a cable tie to the rear of the auger housing for shipping purposes. Cut the cable tie and remove it before operating the unit.
Set-Up
Shear Pins
Holes are located in the plastic dash panel for convenient shear pin storage. See Figure 6. Refer to the Operation section for more informa- tion regarding shear pin replacement.
Figure 4
Figure 5
Figure 6
