•Pull on the cable and rotate it around the bottom of the trigger, with the inner cable in the slot, until the cable end can be pushed into the trigger housing and snapped tight. See Figure 12.
Note: When the cable is installed correctly, you should not be able to pull the cable out of the trigger housing.
•Place the right turn trigger in position underneath the right handle. Secure with screw and weld nut from group H of the hardware pack. See Figure 13. You will need a phillips screwdriver for tightening the screw. Repeat on left side.
| Secure with screw | |
Weld Nut |
| |
| Turn | |
Slot | Trigger | |
Trigger | ||
| ||
| Cable |
Figure 13
•Secure the right turn trigger cable to the right lower handle using cable tie provided in the hardware pack. Make sure not to wrap the drive cable. See Figure 14.
Trigger Cable
Cable Tie
Figure 14
•Secure the left turn trigger cable to the lower handle using the other cable tie. Make sure to route the cable tie below the auger drive cable so that when the trigger cable is secured by the cable tie, the auger drive cable is left outside the cable tie. Trim excess ends from each cable tie.
NOTE: The right side cable tie must be used to keep cable from coming in contact with the moving shift arm from the transmission.
Lamp Wiring
•Wrap the wire from the lamp down the right
handle as shown in Figure 15. | 10 |
|
•Plug wire into the alternator lead wire under the fuel tank. See Figure 15.
Trigger Cable |
Handle |
Alternator |
Lead |
Lamp |
Wire |
Figure 15
IMPORTANT: Assemble your snow thrower, then check the adjustments as instructed and make any final adjustments necessary before operating the unit. Failure to follow the instructions may cause damage to the snow thrower.
Final Adjustments
Auger Control
•To check the adjustment of the auger control, push forward the left hand clutch grip until the rubber bumper is compressed. There should be slack in the clutch cable.
•Release the clutch grip. The cable should be straight. Make certain you can depress the auger control grip against the left handle completely.
•If adjustment is necessary, loosen the hex jam nut and thread the cable in (for less slack) or out (for more slack).
•Recheck the adjustment. Tighten the jam nut against the cable when correct adjustment is reached.
Traction Drive Clutch and Shift Lever
•Tip the snow thrower forward so that it rests on the auger housing.
•Move the shift lever all the way forward to sixth
(6) position.
•With the traction drive lever released, spin the snow thrower wheels by hand. The wheels should turn; however, you may feel some resistance.
•Engage the traction drive clutch grip. The wheels should no longer turn.
•Now release the traction drive clutch grip, and spin the wheels again.
•Move the shift lever back to the fast reverse position, then all the way forward again. There
