![](/images/new-backgrounds/1283388/28338819x1.webp)
I _'WARNINGI The vibrations from operating the
router can, from time to time, cause the hex nut
and the clamp plate to become loose on the clamp rod. PERIODICALLY CHECK THESE FASTENERS
AND ALL FASTENERS to ensure that they are tight and secure.
PUSH BLOCK ASSEMBLY TO THE ROUTER TABLE FENCE
1.Position the clamp plate relative to the push block, as shown in Figure 18.
2.Align the rib on the push block with the groove in the front face of the fence.
3.Assemble the push block to the fence as shown in Figure 18. The push block should move freely along the full length of the fence.
FIGURE 18
Push
Claml
Fence | Plate |
INOTE I There are two round holes in the
miter bar. Make sure the
1. Tighten the screw so that it touches the miter bar
but still provides a resistance to rotating the protractor head.
2.Assemble the knob (Part No. 31
FIGURE 20
| x 3/4" | Long | ||
|
| Round | Head |
|
Miter Bar_ | _quare |
| Neck | Bolt |
| 113164" | I.D. x |
| 9/16" | O.D. x |
ProtractOrHead(_ | .040" | Thick |
| Washer |
Knob
MITER GAUGE ASSEMBLY
Assemble the protractor head (Part No.
FIGURE 19
'_Head Machine Screw
,/ Use this hole
\/
Miter Bar _ | "" _,, |
Protractor Head
DUST COLLECTING ATTACHMENT
The router table fence is equipped with a port at the back for the attachment of the hose from a wet/dry vac
The port will accommodate a
To attach, push the nozzle into the port while holding the fence in place.
_CAUTIONI Operating the router table without
the use of a wet/dry vac may result in an excessive col- lection of saw dust and chips under the fence assembly and the overhead guard. This can hinder the perform- ance of the router table and the fence assembly.
I_WARNINGI When doing the above, keep the following in mind:
•The router table must be turned OFF.
•The router bit must not be turning.
•The router power cord must be unplugged from the outlet.
MOUNTING ROUTER TABLE TO A WORKBENCH OR WORK SURFACE
I_WARNING The router table must always be FIRMLY and SECURELY mounted to a work
10