PREPARING THE SNOW THROWER FOR USE
_ The following section describes steps you must follow to prepare the snow thrower for use. If after reading this section, you are unsure about how to perform any of the
steps please call (888)
Visually Inspect the Snow Thrower
Before using the snow thrower for the first time, be sure that the machine is properly assembled (see the "Assembly" section of this manual). Check that all parts are properly attached and free from damage. If you are unsure about the assembly or condition of any of the snow thrower parts, call the customer help line for service.
Before each use of the snow thrower, check the snow thrower for damaged or missing
components. If parts are damaged or missing, do not attempt to use the machine. Instead, call our customer help line.
Check Tire Inflation
Before each use of the snow thrower, check the tire pressure. The pressure of the two tires should be equal and in the range of
The pressure can be checked using an ordinary tire pressure gauge. Fill the tires using a portable air compressor or other compressed air source. NOTE: Do not
Add/Check Oil
If this is' your first time using this snow thrower:
The snow thrower requires engine oil to operate properly. from the package, contains 17ooil in the engine crankcase. thrower for the first time, follow these steps:
The snow thrower, when new To add oil to your snow
1.Make sure the snow thrower is fully assembled and on a level surface.
2.Unscrew the oil filler cap from the engine crankcase as shown in figure 6.
3.Using a funnel, add approximately 21 fluid oz. of motor oil. Use a regular car motor oil that performs well in cold conditions. The temperature conditions and recommended oil grade will vary by geographic area.
4.Wipe the dipstick attached to the oil filler cap with a clean dry cloth. Now replace the cap.
13
