=Clean the Shuttle Race
ThJs area must be kept free of dust, lint and occasional tangled thread. Clean the shuttle race area about every three months.
Center | pm | et |
|
the shuttle | Shuttle | driver | |
Lever
Shuttle
Lever
Shuttle Race
ever
Shuttle Race
Cover
case
To Clean the Shuttle Area:
1.Raise the needle bar to its highest point and remove the bobbin case.
2.Push shuttle race levers aside. Lift shuttle race cover and take shuttle out.
3.Clean the shuttle race with a lint brush,
4, Put a drop of oil on the center pin of the shuttle and shuttle race. Do not
To Replace Shuttel Assembly:
I, Position shuttle race as illustrated so that shuttle driver is forming half moon on the left side of the machme.
2, Hold shuttle by center p=n and position shuttle so as to form a half moon on the right side° Pointed hook wifl be on the bottom.
3.Place shuttle race cover rote place over shuttle assembly.
4.Snapthe levers back into the ongmat position.
44
