Sears 385. 19601 owner manual Fit

o Cf_eck YaurPresser	Foot
Your presser toot Is held		in place		by	a Foot	Holder.	Each	presser	toot
merely snaps on the	toot	holder,	which		is seldom	removed.
If you need to remove	or	attach	the	toot	holder,	here is	what	you do:

SECTION 2. PREPARE YOUR MACHINE FOR SEWING

o Change the Presser Foot

Use the correct presser toot _or the stitch Yoo wish to sew. Consult the Stitch Pattern

Chart and the detailed directions _or sew_n_j with the varloUs presser _eet.

To	Remove:		To	Attach:
	Foo_
To	Remove:		To	Attach;
Turn the screw		toward	the back Of I.	Match	the	hole	in	the	toot
tile	maehine.	Use the	large screw	holder	with	the threaded			hole
driver.				in the presser		bar,
			2.	Fit the	lOOt	holder		screw	_nto
				the hole.
			3.	Tighten	the	screw	by	tumm	9 _t
				toward	you.

To snap of :

1_ p/DOw

b_tten

meyer

To Snap Off the Presser Foot:

l, Press the Up/Down Needle PosLtion Button to raise the needle to _ts highest position.

2, Raise the presser toot_

3, Press the red button on the back ot the toot

bolder. The presser tOOt will drop oil,

To Snap On:

To Snap On the Presse_

Foot:

h Set the Pressure Dial at

2+ Place the presse_ toot So tire hor+zonta! pm on the _oot lies lust under

the groove ot the toot holder.

3, Lower the presser foot

bolder to lock the presser toot m place.

NOTE: If you do not hear the presser toot soap _o place, press down on the presser

_ioot holder firmtv until you hear the snap.

t5